1. Skip to navigation
  2. Skip to content
  3. Skip to sidebar

Solutions Search - PoE Powered Device (PD)

LTspice SOAtherm Support for PCB and Heat Sink Thermal Models

Dan Eddleman - Senior Applications Engineer Sep 1st 2016
The SOAtherm model distributed with LTspice software and simplifies Hot Swap and Surge Stopper designs by verifying directly within a circuit simulation that a particular MOSFET’s Safe Operating Area (SOA) is not exceeded. This article assumes a basic understanding of the SOAtherm model. If you are not familiar with SOAtherm, ...

Blog Post LTspice 

 

LT4321/LT4275 LTPoE++/PoE+/PoE PD Controller TechClips

Oct 24th 2013
Power over ethernet is a continuing trend in the Ethernet world. The current IEEE standard allows for up to 25.5W of PD input power. LTPoE++ is Linear Technology's solution to meet the demand for greater power with 38.7W, 52.7W, 70W and 90W power levels. Heat generated by Power Over Ethernet powered device (PD) is a design ...

Blog Post Video 

 

Active Bridge Rectifiers Reduce Heat Dissipation within PoE Security Cameras

Ryan Huff - PoE Applications Engineer Oct 1st 2013
Introduction Power over Ethernet (PoE) has been embraced by the video surveillance industry as a solution to an age-old problem: complicated cabling. For instance, a basic, traditional fixed-view security camera requires two cables: one for power (10W to 15W from a 24V AC or 12V DC), and a separate, coax cable for the video ...

Blog Post