1. Skip to navigation
  2. Skip to content
  3. Skip to sidebar

Solutions Search - Extended Temperature (H & MP) Timing

LTC6258 Low Power Squarewave - Sinewave Oscillator

Aug 30th 2017
A low power sine wave generator can be derived by driving a square wave into the bandpass filter. A complete schematic is shown in Figure 4a. The LTC6992-1 easily configures as a 50% duty cycle 10kHz square wave, and can drive the relatively benign loading seen in the bandpass filter. Figures 4b and 4c show the LTC6992-1 output ...

Circuit LTspice 

 

LTC3623 12V to 10A 2-Phase Single Output Regulator

Aug 15th 2016
TheLTC3623 is a high efficiency, monolithic synchronous buck regulator in which the output voltage is programmed with a single external resistor. The accurate internally generated 50µA current source on the ISET pin allows the user to program an output voltage from 0V to 0.5V below VIN. The user can also directly drive ...

Circuit 

 

High Accuracy, μPower, Over-Voltage Detector with Glitch Suppressor Using LTC1541 and LTC6994

May 4th 2016
An overvoltage detector which suppresses glitches is constructed from the LTC®1541 micropower op amp + comparator + voltage reference and LTC6994-1 TimerBlox® delay block/debouncer. In this circuit, the LTC1541 comparator detects power rail overvoltage conditions (including glitches). The built-in op amp inverts this ...

Circuit LTspice 

 

LTC7138 5V to 140V Input to 5V/400mA Output with 20kHz Minimum Switching Frequency

Jan 14th 2015
The LTC®7138 is a high efficiency step-down DC/DC regulator with internal power switch that draws only 12μA typical DC supply current while maintaining a regulated output voltage at no load. ...

Circuit 

 

LTM4639 1V at 40A, uModule With Two Parallel Outputs with 2-Phase Operation, 350kHz

Nov 24th 2014
The LTM®4639 is a complete 20A output high efficiency switch mode step-down DC/DC μModule (micromodule) regulator. Included in the package are the switching controller, power FETs, inductor and compensation components. Operating over an input voltage range from 2.375V to 7V, the LTM4639 supports an output voltage range ...

Circuit 

 

LTC6993-1 Staircase Generator with Reset

Aug 7th 2014
The LTC®6993 is a monostable multivibrator (also known as a “one-shot” pulse generator) with a programmable pulse width of 1μs to 33.6 seconds. The LTC6993 is part of the TimerBlox® family of versatile silicon timing devices. ...

Circuit LTspice 

 

LTC6992-1 1MHz Pulse Width Modulator

Aug 7th 2014
The LTC®6992 is a silicon oscillator with an easy-to-use analog voltage-controlled pulse width modulation (PWM) capability. The LTC6992 is part of the TimerBlox® family of versatile silicon timing devices. ...

Circuit LTspice 

 

LTC6991 Intervalometer for Time-Lapse Photography

Aug 7th 2014
The LTC®6991 is a silicon oscillator with a programmable period range of 1.024ms to 9.54 hours (29.1μHz to 977Hz), specifically intended for long duration timing events. The LTC6991 is part of the TimerBlox® family of versatile silicon timing devices. ...

Circuit LTspice 

 

LTC6993-1 Consecutive Test Sequencer

Aug 7th 2014
The LTC®6993 is a monostable multivibrator (also known as a “one-shot” pulse generator) with a programmable pulse width of 1μs to 33.6 seconds. The LTC6993 is part of the TimerBlox® family of versatile silicon timing devices. ...

Circuit LTspice 

 

LTC6994-1 Delayed One-Shot

Aug 7th 2014
The LTC®6994 is a programmable delay block with a range of 1μs to 33.6 seconds. The LTC6994 is part of the TimerBlox® family of versatile silicon timing devices. ...

Circuit LTspice 

 

LTC6990 Isolated Voltage to Frequency Converter. VIN Provided by Isolated Measurement Circuit. 5μs Rise/Fall Time of Isolator Limits fMAX to 60kHz

May 12th 2010
The LTC®6990 is a precision silicon oscillator with a programmable frequency range of 488Hz to 2MHz. It can be used as a fixed-frequency or voltage-controlled oscillator (VCO). The LTC6990 is part of the TimerBlox® family of versatile silicon timing devices. A single resistor, RSET, programs the LTC6990’s internal ...

Circuit 

 

LTC6990 Full Range Temperature to Frequency Converter. 16kHz to 1kHz from –20°C to 80°C

May 12th 2010
The LTC®6990 is a precision silicon oscillator with a programmable frequency range of 488Hz to 2MHz. It can be used as a fixed-frequency or voltage-controlled oscillator (VCO). The LTC6990 is part of the TimerBlox® family of versatile silicon timing devices. A single resistor, RSET, programs the LTC6990’s internal ...

Circuit 

 

LTC6990 Full Range VCO with Any NDIV Setting (Positive Frequency Control, fMIN to fMAX for VIN = 0V to VSET

May 12th 2010
The LTC®6990 is a precision silicon oscillator with a programmable frequency range of 488Hz to 2MHz. It can be used as a fixed-frequency or voltage-controlled oscillator (VCO). The LTC6990 is part of the TimerBlox® family of versatile silicon timing devices. A single resistor, RSET, programs the LTC6990’s internal ...

Circuit 

 

Isolated PWM (5% to 95%) Controller

May 12th 2010
The LTC6992 is a silicon oscillator with an easy-to-use analog voltage-controlled pulse width modulation (PWM) capability. The LTC6992 is part of the TimerBlox family of versatile silicon timing devices. A single resistor, RSET, programs the LTC6992’s internal master oscillator frequency. The output frequency is determined ...

Circuit 

 

LTM4627 1V at 30A, Two Parallel Outputs with 2-Phase Operation

Mar 24th 2006
The LTM4627 is a complete 15A output high efficiency switch mode DC/DC power supply. Included in the package are the switching controller, power FETs, inductor and compensation components. Operating over an input voltage range from 4.5V to 20V, the LTM4627 supports an output voltage range of 0.6V to 5V, set by a single external ...

Circuit 

 

LTM4637 3.3V at 40A, Two Parrallel Outputs with 2-Phase Operation

Mar 24th 2006
The LTM®4637 is a complete 20A output high efficiency switch mode step-down DC/DC μModule (micromodule) regulator. Included in the package are the switching controller, power FETs, inductor and compensation components. Operating over an input voltage range from 4.5V to 20V, the LTM4637 supports an output voltage range ...

Circuit 

 

LTM4601HV 2-Phase Parallel, 3.3V at 20A Design

Mar 24th 2006
The LTM4601HV is a complete 12A step-down switch mode DC/DC power supply with onboard switching controller, MOSFETs, inductor and all support components. The µModule regulator is housed in small surface mount 15mm × 15mm × 2.82mm LGA and 15mm × 15mm × 3.42mm BGA packages. Operating over an input ...

Circuit 

 

LTM4612 2-Phase, Parallel 12V at 10A Design

Mar 24th 2006
The LTM®4612 is a EN55022 Class B certified high voltage input and output, 5A switching mode DC/DC power supply. Included in the package are the switching controller, power FETs, inductor and all support components. Operating over an input voltage range of 5V to 36V, the LTM4612 supports an output voltage range of 3.3V to ...

Circuit 

 

LTM4611 1V at 30A LTM4611 Two Parallel Outputs with 2-Phase Operation

Mar 24th 2006
The LTM4611 is a high density 15A output, switch mode DC/DC buck converter power supply capable of operating from very low voltage input supplies. Included in the package are the buck switching controller, power FETs, inductor and loop-compensation components. The LTM4611 delivers up to 15A continuous current at high efficiency ...

Circuit 

 

LTM4609 Two-Phase Parallel, 12V at 8A Design

Mar 24th 2006
The LTM®4609 is a high efficiency switching mode buckboost power supply. Included in the package are the switching controller, power FETs and support components. Operating over an input voltage range of 4.5V to 36V, the LTM4609 supports an output voltage range of 0.8V to 34V, set by a resistor. This high efficiency design ...

Circuit LTpowerCAD