1. Skip to navigation
  2. Skip to content
  3. Skip to sidebar

DC2155A-A - LTC3886UKG Demo Board (RSENSE) Dual Phase Dual Output PMBus Buck 18V≤VIN≤54V, VOUT0/VOUT1=5V to 12V at 12A per channel, 150kHz

Demonstration circuit 2155A is available in two configurations. The DC2155A-A is a dual output synchronous step-down converter featuring the LTC®3886IUKG, a dual-phase current mode controller. The DC2155A-B is a single output synchronous step-down converter that operates with four phases: two from the LTC3886IUKG and two from LTC3870EUFD, a phase extender. Both versions have a PMBus interface and digital power system management functions.

DC2155A-A - Schematic

 

Companion Demo Boards

DC1613A - USB-to-PMBus Controller for Use with LTpowerPlay



Software

LTpowerPlay

LTpowerPlay is a powerful development environment supporting Linear Technology's Digital Power System Management (PSM) products, providing unprecedented diagnostic and debug features.

Click here to download LTpowerPlay

LTspice

LTspice® software is a powerful, fast and free simulation tool, schematic capture and waveform viewer with enhancements and models for improving the simulation of switching regulators. Click here to download LTspice

To launch a ready to run LTspice demonstration circuit for this part:

To explore other ready to run LTspice demonstration circuits, please visit our Demo Circuits Collection.

LTpowerCAD

The LTpowerCAD design tool is a complete power supply design tool program that can significantly ease the tasks of power supply design. It guides users to a solution, selects power stage components, provides detailed power efficiency, shows quick loop bode plot stability and load transient analysis, and can export a final design to LTspice for simulation. Click here to download LTpowerCAD

To open the project file for this circuit:

  • Step 1: If you have not installed LTpowerCAD on this computer, download and install LTpowerCAD
  • Step 2: Once LTpowerCAD is installed, click on the link(s) below to open the project file
  • Step 3: If LTpowerCAD does not automatically open after clicking the link above, you can open the project file by right clicking on the link and selecting "Save Target As." After saving the file to your computer, start LTpowerCAD and open the project file by selecting 'Open Project' from the 'File' menu