1. Skip to navigation
  2. Skip to content
  3. Skip to sidebar

DC2405A - LTM2893 Demo Board | 100MHz SPI uModule Isolator

Demonstration circuit 2405A shows an LTM®2893 isolating and interfacing an LTC®2328-18. The LTM2893 is a high speed SPI isolator for interfacing read only ADCs with a full complement of control signals. The LTC2328-18 is a low noise, high speed 18-bit successive approximation register (SAR) ADC. Low noise isolated power is delivered to the isolated side with an LT3999 push-pull driver and isolation transformer.

DC2405A - Schematic

 

Companion Demo Boards

DC2026C - Linduino One Isolated USB Demo Board: An Arduino- and QuikEval-Compatible Code Development Platform
DC590B - Isolated USB Serial Controller for Linear Technology QuikEval-Compatible Demo Boards
DC890B - USB Data Acquisition Controller, for PScope Evaluation Kits (up to 250Mbps, CMOS/LVDS)



Software

QuikEval System

The QuikEval system is a USB-based product demonstration and data acquisition system that allows users to quickly evaluate the performance of Linear Technology products. The system consists of a USB Data Acquisition Controller board (DC590B) that connects to individual daughter cards for specific Linear Technology products.

Click here to download QuikEval

PScope

The PScope System is a USB-based product demonstration and data acquisition system for use with Linear Technology’s high performance ADCs and signal chain receiver family. PScope allows users to evaluate the SNR, SFDR, THD, as well as other key parameters, quickly and easily.  Use PScope software with the DC718, DC890 and DC1371 Data Collection Boards.

Click here to download PScope

Linduino

Linduino is an Arduino compatible platform for developing and distributing firmware libraries and code for SPI and I²C-compatible integrated circuits. The Linduino One board interfaces to more than 300 QuikEval demonstration cards, supporting a variety of product types including analog-to-digital converters (ADCs)digital-to-analog converters (DACs)power monitors, and more. Firmware libraries for individual devices are written in C and designed to be portable to a wide variety of processors and microcontrollers. Each library has a demonstration program that can be uploaded to the Linduino One platform to allow the circuit and software to be quickly and easily verified.

Click here for more information on Linduino