1. Skip to navigation
  2. Skip to content
  3. Skip to sidebar

DC2016A - LTM8054 Demo Board | uModule Sync Buck-Boost, 6V ≤ VIN ≤ 35V, Vout = 12V @ 1.8A to 3A

Demonstration circuit 2016A features the LTM8054, a synchronous buck-boost μModule regulator that accepts input voltages lower, higher or the same as the output, but is also highly efficient due to its four-switch architecture. The output for DC2016A is 12V and the input voltage range is 6V to 35V – see the LTM8054 data sheet for application circuits with input voltages up to 36V. The maximum output current of DC2016A is 3A and the switching frequency is 600kHz.

DC2016A Schematic

DC2016A demo board

 


Software

LTspice

LTspice® software is a powerful, fast and free simulation tool, schematic capture and waveform viewer with enhancements and models for improving the simulation of switching regulators. Click here to download LTspice

To launch a ready to run LTspice demonstration circuit for this part:

To explore other ready to run LTspice demonstration circuits, please visit our Demo Circuits Collection.

LTpowerCAD

The LTpowerCAD design tool is a complete power supply design tool program that can significantly ease the tasks of power supply design. It guides users to a solution, selects power stage components, provides detailed power efficiency, shows quick loop bode plot stability and load transient analysis, and can export a final design to LTspice for simulation. Click here to download LTpowerCAD

To open the project file for this circuit:

  • Step 1: If you have not installed LTpowerCAD on this computer, download and install LTpowerCAD
  • Step 2: Once LTpowerCAD is installed, click on the link(s) below to open the project file
  • Step 3: If LTpowerCAD does not automatically open after clicking the link above, you can open the project file by right clicking on the link and selecting "Save Target As." After saving the file to your computer, start LTpowerCAD and open the project file by selecting 'Open Project' from the 'File' menu