DC2164A-A - LTM4630EY-1 Demo Board | 2 Paralleled Buck μModules, 4.5V ≤ VIN ≤ 15V, Vout = 0.9V to 1.8V @ 70A
Demonstration Circuit 2164A-A features a PolyPhase® design using two paralleled LTM®4630EY-1's (A-grade), the high efficiency, high density, dual 18A, switch mode step-down power module regulator. The input voltage is from 4.5V to 15V. The output voltage is jumper selectable and can be set to 0.9V, 1.0V, 1.2V, 1.5V or 1.8V. DC2164A-A can deliver nominal 70A output current. As explained in the data sheet, output current derating is necessary for certain VIN, VOUT, and thermal conditions. The LTM4630-1A on DC2164A-A always operate in continuous conduction mode. The switching frequency can be programmed through a resistor or can be synchronized to an external clock signal. The board allows the user to program how its output voltage ramps up and down through the TRACK pin.
Software
LTpowerCAD
The LTpowerCAD design tool is a complete power supply design tool program that can significantly ease the tasks of power supply design. It guides users to a solution, selects power stage components, provides detailed power efficiency, shows quick loop bode plot stability and load transient analysis, and can export a final design to LTspice for simulation. Click here to download LTpowerCAD
To open the project file for this circuit:
- Step 1: If you have not installed LTpowerCAD on this computer, download and install LTpowerCAD
- Step 2: Once LTpowerCAD is installed, click on the link(s) below to open the project file
- Step 3: If LTpowerCAD does not automatically open after clicking the link above, you can open the project file by right clicking on the link and selecting "Save Target As." After saving the file to your computer, start LTpowerCAD and open the project file by selecting 'Open Project' from the 'File' menu
View More Step Down DC-DC Solutions (Vin > Vout) Solutions
View All - List View • Table View
