DC1641A - LTC3786 MS16E Demo Board 5V VIN 24V; VOUT = 24V @ Up to 10A
Demonstration circuit DC1641 is DC/DC boost converter featuring the LTC3786 constant frequency current mode boost controller. The DC1641A operates over 5V to 24V input and provides over 5A at 6V input voltage and over 9A of output current at 10V input as shown in figure 3. The 350kHz constant frequency operation results in small and efficient circuit. The converter provides high output voltage accuracy (typically ±3%) over wide load range with no minimum load requirement. The demonstration circuit can be easily modified to generate different output voltages.
Software
LTspice
LTspice® software is a powerful, fast and free simulation tool, schematic capture and waveform viewer with enhancements and models for improving the simulation of switching regulators. Click here to download LTspice
To launch a ready to run LTspice demonstration circuit for this part:
- Step 1: If you have not installed LTspice on this computer, download and install LTspice
- Step 2: Once LTspice is installed, click on the link(s) below to launch the simulation
- Step 3: If LTspice does not automatically open after clicking the link above, you can instead run the simulation by right clicking on the link and selecting "Save Target As." After saving the file to your computer, start LTspice and open the demonstration circuit by selecting 'Open' from the 'File' menu
To explore other ready to run LTspice demonstration circuits, please visit our Demo Circuits Collection.
LTpowerCAD
The LTpowerCAD design tool is a complete power supply design tool program that can significantly ease the tasks of power supply design. It guides users to a solution, selects power stage components, provides detailed power efficiency, shows quick loop bode plot stability and load transient analysis, and can export a final design to LTspice for simulation. Click here to download LTpowerCAD
To open the project file for this circuit:
- Step 1: If you have not installed LTpowerCAD on this computer, download and install LTpowerCAD
- Step 2: Once LTpowerCAD is installed, click on the link(s) below to open the project file
- Step 3: If LTpowerCAD does not automatically open after clicking the link above, you can open the project file by right clicking on the link and selecting "Save Target As." After saving the file to your computer, start LTpowerCAD and open the project file by selecting 'Open Project' from the 'File' menu
View More Step Up DC-DC Solutions (Vin < Vout) Solutions
View All - List View • Table View
