DC1580A - LTC3856EUH Demo Board | 4.5V ≤ VIN ≤ 14V, VOUT = 1.5V @ 50A
Demonstration circuit 1580A is a high efficiency, polyphase, synchronous buck converter with a 4.5V to 14V input range. It can supply 50A maximum load current at 1.5V output. The demo board uses the LTC®3856EUH controller. The LTC3856 is a feature-rich single-output dual-phase synchronous buck controller with on-chip drivers and remote differential output voltage sensing. This board is setup with sense resistor configuration with optional inductor DCR sensing circuit.
Software
LTspice
LTspice® software is a powerful, fast and free simulation tool, schematic capture and waveform viewer with enhancements and models for improving the simulation of switching regulators. Click here to download LTspice
To launch a ready to run LTspice demonstration circuit for this part:
- Step 1: If you have not installed LTspice on this computer, download and install LTspice
- Step 2: Once LTspice is installed, click on the link(s) below to launch the simulation
- Step 3: If LTspice does not automatically open after clicking the link above, you can instead run the simulation by right clicking on the link and selecting "Save Target As." After saving the file to your computer, start LTspice and open the demonstration circuit by selecting 'Open' from the 'File' menu
To explore other ready to run LTspice demonstration circuits, please visit our Demo Circuits Collection.
LTpowerCAD
The LTpowerCAD design tool is a complete power supply design tool program that can significantly ease the tasks of power supply design. It guides users to a solution, selects power stage components, provides detailed power efficiency, shows quick loop bode plot stability and load transient analysis, and can export a final design to LTspice for simulation. Click here to download LTpowerCAD
To open the project file for this circuit:
- Step 1: If you have not installed LTpowerCAD on this computer, download and install LTpowerCAD
- Step 2: Once LTpowerCAD is installed, click on the link(s) below to open the project file
- Step 3: If LTpowerCAD does not automatically open after clicking the link above, you can open the project file by right clicking on the link and selecting "Save Target As." After saving the file to your computer, start LTpowerCAD and open the project file by selecting 'Open Project' from the 'File' menu
View More Step Down DC-DC Solutions (Vin > Vout) Solutions
View All - List View • Table View
