1. Skip to navigation
  2. Skip to content
  3. Skip to sidebar

Solutions Power Management Switching Regulator Step-Down (Buck) Regulators Micropower Buck Regulators
Solutions Power Management Switching Regulator Step-Down (Buck) Regulators Internal Power Switch Buck
Solutions Power Management Switching Regulator DDR Memory/Bus Termination
Solutions DC Regulator Solutions DC-DC Voltage Regulation Step Down DC-DC Solutions (Vin > Vout)

DC1467A - LTC3614EUDD Demo Board | 4A, 4MHz Monolithic Synchronous Step-Down DC/DC Converter

Demo Circuit 1467 is a high efficiency, high frequency step-down converter, incorporating the LTC3614 monolithic synchronous regulator. The DC1467A has an input voltage range of 2.25V to 5.5V, and is capable of delivering up to 4A of output current. The output voltage of the DC1467A can be set as low as 0.6V, the reference voltage of the LTC3614. The operating frequency range of the DC1467A is either set to a fixed 2.25 MHz by connecting the frequency pin to SVin, set by an external resistor, or synchronized to an external clock, with a range up to 4 MHz. At low load currents, the DC1467A can operate in either noise sensitive applications, due to the capability of the LTC3614 to operate in pulse-skipping mode, or in high efficiency applications, because the LTC3614 also has Burst-Mode capability. The Burst Mode clamp can be set externally.

DC1467A - Schematic

 


Software

LTpowerCAD

The LTpowerCAD design tool is a complete power supply design tool program that can significantly ease the tasks of power supply design. It guides users to a solution, selects power stage components, provides detailed power efficiency, shows quick loop bode plot stability and load transient analysis, and can export a final design to LTspice for simulation. Click here to download LTpowerCAD

To open the project file for this circuit:

  • Step 1: If you have not installed LTpowerCAD on this computer, download and install LTpowerCAD
  • Step 2: Once LTpowerCAD is installed, click on the link(s) below to open the project file
  • Step 3: If LTpowerCAD does not automatically open after clicking the link above, you can open the project file by right clicking on the link and selecting "Save Target As." After saving the file to your computer, start LTpowerCAD and open the project file by selecting 'Open Project' from the 'File' menu

View More Step Down DC-DC Solutions (Vin > Vout) Solutions

LTC3859A Demo Board | Triple Output, Buck/Buck/Boost, 4.5V ≤ VIN ≤ 36V, Vout1 = 5V @ 5A, Vout2 = 8.5V @ 3A, Vout3 = 10V @ 2A
LTC3774EUHE Demo Board | Sync Buck Controller, 4-Phase (LTC3774 x2), 10V ≤ VIN ≤ 14V, Vout = 1.2V @ 120A

View All - List View • Table View