DC701A - LTC3407EDD Demo Board | (DFN) Vin = 2.5V to 5.5V, Vout1 = 1.2V / 1.5V / 1.8V @ 600mA, Vout2 = 2.5V @ 600mA
Demonstration circuit 701 is a Dual Synchronous, 600mA, 1.5MHz Step-Down DC/DC Regulator featuring the LTC3407 in the 3x3 DFN-10 package. The DC701 has an input voltage range of 2.5V to 5.5V, and either output is capable of delivering up to 600mA of output current. In Burst Mode® operation, the LTC3407 requires only 40uA of quiescent current; in Pulse Skip mode, the LTC3407 provides lower output ripple voltage at light load currents. The DC701 can provide up to 96% efficiency on either channel and consumes less than 1uA in shutdown.
Software
LTspice
LTspice® software is a powerful, fast and free simulation tool, schematic capture and waveform viewer with enhancements and models for improving the simulation of switching regulators. Click here to download LTspice
To launch a ready to run LTspice demonstration circuit for this part:
- Step 1: If you have not installed LTspice on this computer, download and install LTspice
- Step 2: Once LTspice is installed, click on the link(s) below to launch the simulation
- Step 3: If LTspice does not automatically open after clicking the link above, you can instead run the simulation by right clicking on the link and selecting "Save Target As." After saving the file to your computer, start LTspice and open the demonstration circuit by selecting 'Open' from the 'File' menu
To explore other ready to run LTspice demonstration circuits, please visit our Demo Circuits Collection.
LTpowerCAD
The LTpowerCAD design tool is a complete power supply design tool program that can significantly ease the tasks of power supply design. It guides users to a solution, selects power stage components, provides detailed power efficiency, shows quick loop bode plot stability and load transient analysis, and can export a final design to LTspice for simulation. Click here to download LTpowerCAD
To open the project file for this circuit:
- Step 1: If you have not installed LTpowerCAD on this computer, download and install LTpowerCAD
- Step 2: Once LTpowerCAD is installed, click on the link(s) below to open the project file
- Step 3: If LTpowerCAD does not automatically open after clicking the link above, you can open the project file by right clicking on the link and selecting "Save Target As." After saving the file to your computer, start LTpowerCAD and open the project file by selecting 'Open Project' from the 'File' menu
View More Step Down DC-DC Solutions (Vin > Vout) Solutions
View All - List View • Table View
