LT1567 A Differential Input-to-Single-Ended Output Amplifier

This circuit shows a circuit for converting a differential input to a single-ended output. For a gain equal to one (R1 = R2 = 604W and VOUT = V2 – V1) the input referred differential voltage noise density is 9nV/rtHz and differential input signal-to-noise ratio is 80.9dB with 0.2VRMS input signal in a 4MHz noise bandwidth. The input AC common mode rejection depends on the matching of resistors R1 and R3 and the LT1567 inverter gain tolerance (common mode rejection is at least 40dB up to 1MHz with one percent resistors and two percent inverter gain tolerance).

Software

LTspice

LTspice^® software is a powerful, fast and free simulation tool, schematic capture and waveform viewer with enhancements and models for improving the simulation of switching regulators. Click here to download LTspice

To launch a ready to run LTspice demonstration circuit for this part:

Step 1: If you have not installed LTspice on this computer, download and install LTspice
Step 2: Once LTspice is installed, click on the link(s) below to launch the simulation
- LT1567 Demo Circuit - Differential Input-to-Single-Ended Output Amplifier
Step 3: If LTspice does not automatically open after clicking the link above, you can instead run the simulation by right clicking on the link and selecting "Save Target As." After saving the file to your computer, start LTspice and open the demonstration circuit by selecting 'Open' from the 'File' menu

To explore other ready to run LTspice demonstration circuits, please visit our Demo Circuits Collection.