1. Skip to navigation
  2. Skip to content
  3. Skip to sidebar

LTC6081 Two Op Amp Instrumentation Amplifier

Two Op Amp Instrumentation Amplifier

Instrumentation amplifiers present a high input impedance to a differential input signal source and provide a single ended output. This circuit uses the non-inverting inputs of each amplifier of the dual LTC6081 for the differential input terminals. The gain is set with external resistors to over 1000. A CMRR trim cancels the effects of resistor value tolerances that may create differential signals from input common mode voltage changes.

 


Software

LTspice

LTspice® software is a powerful, fast and free simulation tool, schematic capture and waveform viewer with enhancements and models for improving the simulation of switching regulators. Click here to download LTspice

To launch a ready to run LTspice demonstration circuit for this part:

  • Step 1: If you have not installed LTspice on this computer, download and install LTspice
  • Step 2: Once LTspice is installed, click on the link(s) below to launch the simulation
  • Step 3: If LTspice does not automatically open after clicking the link above, you can instead run the simulation by right clicking on the link and selecting "Save Target As." After saving the file to your computer, start LTspice and open the demonstration circuit by selecting 'Open' from the 'File' menu

To explore other ready to run LTspice demonstration circuits, please visit our Demo Circuits Collection.